NATO style watch strap in Bond 007 Regimental colours

(1 customer review)

£9.99

FREE UK DELIVERY. A high quality ballistic nylon NATO style watch strap in the ORIGINAL James Bond colours. This strap features 3 x navy blue stripes, two army green and a thin red piping separating each band. This watch strap is available in both 22mm and 24mm width (lug to lug) with 3 x brushed steel buckles (2 above and 1 below the watch)

Clear
SKU: N/A Category: Tag:

Description

Made of the highest quality materials with heat sealed holes and ends. Marine quality stainless steel. The fabric used is soft but but very strong ballistic nylon – 1.4mm thick. We tested many straps before deciding on this one to sell directly. These NATO watch straps give the “Bond 007” look to any watch. I have them installed on my Bremont Supermarine S500 and they look fantastic. This version features the traditional / original Bond colours of red, blue and army green. Quality guaranteed

Specification of all watch straps

  • FREE UK delivery (Royal Mail First class – will fit through letter box)
  • Style – NATO strap in Bond Regimental colours (red, green, blue)
  • Length (in total excluding end buckle) – 28cm / 11 inches
  • 13 pre-made (heat sealed) holes
  • Will fit wrists from 16cm to 22cm
  • Width – 20mm and 22mm
  • Stainless Steel Buckles – 3 (as shown in photos)
NATO watch straps are preferred by the military and other active outdoor types because of the ONE PIECE design. If one of the spring bars fail the watch won’t fall from the wrist. It will remain attached to the watch strap by the one remaining spring bar. If a spring bar fails on a TWO piece strap – your watch will fall to the ground. We have some more of the popular NATO watch straps for sale here

Will it fit your watch

This strap is available from 18mm to 24mm. If you don’t know the width of your lugs measure them with a ruler or even better some digital calipers. Measure from LUG to LUG – the area where the strap sits housing the spring bars.

Important – FITTING instructions

Where the gap between the spring bar and watch case is LESS than 1.5mm (about the thickness of the strap) it may be necessary to remove the spring bars before fitting the strap. Normally simply slide the strap under the two spring bars. If the gap is too tight you may have to remove the spring bars to fit the new strap. FORCING the strap between the gap may damage the heat sealed holes. If in any doubt REMOVE the spring bars first. If the strap slides in without too much resitance that’s fine just pull it slowly through.

Additional information

Weight.02 g
DimensionsN/A
Size

22mm, 24mm

1 review for NATO style watch strap in Bond 007 Regimental colours

  1. Mark Jones

    I have bought similar from eBay in the past but been disappointed in quality. These are the REAL DEAL 5/5 star review from me.

Add a review

Your email address will not be published.

You may also like…